Was this support article useful? YES Thank you for your feedback. Feedback Please tell us how we can make this article useful. Software does not include any Open Source Software as defined below. As part of this license, you may A operate the Software in the manner described in the user documentation for the Software; B where the Software is provided for download onto a personal computer or mobile device, make as many copies of the Software as you reasonably need for your own use this does not include firmware ; and C permanently transfer all of your rights to use the Product including but not limited to the Software to another person, so long as that person also agrees to be bound by this Agreement, and following such transfer you stop using the Product and the Software. The Software is licensed, not sold, to you.
|Country:||Saint Kitts and Nevis|
|Published (Last):||23 April 2011|
|PDF File Size:||7.20 Mb|
|ePub File Size:||10.11 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page 5: Chapter 1: Product Overview Product Overview is flashing, the Router is sending or receiving data over the network. The Router lets you access the Internet via The distance between the slots is mm 6 inches. Two screws are needed to mount the Router. Suggested Mounting Hardware mm Enable encryption Wireless Security Checklist Encryption protects data transmitted over a wireless network. If you supply a host and domain name for the Router. This number cannot be greater than Operating Mode allows you to select the type s of advanced functions you use.
Click Delete This Entry to delete a static route. Select any channel from the drop- down menu. If you are not sure which channel to select, keep the default, Auto. Standard Channel If 20MHz only is the Channel Width setting, then select the appropriate channel for your wireless network.
Enter the PIN number listed on this screen. It is also method and shared key, or else the network will listed on the label on the bottom of the Router. Wireless devices will be able to communicate with the Router but not with each other.
To use this option, select Enable. AP Isolation is disabled by default. To use this option, keep the default, Auto. This option is disabled by default. To enable a policy, select the policy number from the drop-down menu, and select Enabled. To create a policy, follow steps If you assigned a static IP address to the computer, then you Check and ending port numbers of the forwarded port number with the Internet application documentation for more range.
For example, if you want to allocate bandwidth for FTP, you can enter If you need services for an application that uses from to , you enter as your settings.
Otherwise, select Disabled. Ping checks the status of a connection. Packet Size Enter the packet size you want to use. Click OK. The Router does not have a coaxial port for the cable Troubleshooting connection. The Router does not replace your modem. You still need Your computer cannot connect to the Internet. Connect your cable connection to the cable modem, and then Follow these instructions until your computer can connect insert the setup CD into your computer.
Also, due to the Warranty Information continual development of new techniques for intruding upon and attacking networks, Linksys does not warrant that the product, software or any equipment, system or Limited Warranty network on which the product or software is used will be You are responsible for properly packaging and shipping your product to Linksys at your cost and risk.
Wireless-N Home Router
Page 5: Chapter 1: Product Overview Product Overview is flashing, the Router is sending or receiving data over the network. The Router lets you access the Internet via The distance between the slots is mm 6 inches. Two screws are needed to mount the Router.
WRT120N User Guides